My Favorite Push Blocks
Comments are locked. The comments explain why this isn’t as safe as it could be.
Terribly dangerous, you should never be pushing the waste material back into the blade after it’s been cut. Great way to get kickback.
You are correct, and I agree with you. I can see how it looks as if I’m doing that in the video, but I’m not. I only apply side pressure before blade.
And I’d really like to see some sort of splitter or riving knife
Yeah if the inward force was limited to before the blade only that’s fine, but even then a riving knife for boards that want to warp in is good… although it isn’t like saw tables always came with one.
I don’t understand what you’re seeing. When is he pushing waste material back into the blade? What am I missing or misunderstanding?
When he makes the cut his second push stick with the cross notches at the end of it. He’s putting inward pressure with it on the waste material the entire time he pushes through the cut. That pressure is fine for material before it gets to the blade but never after. Same reason you never use a feather board at or past the blade, always before.
Yup, got it now. Thanks.
Same reason why this guy got kick back.
Left hand push stick is pushing the offcut towards the blade. Big no no!
Ahhh, OK. Thanks. I didn’t catch that.
No riving knife? Especially if you want to push into the fence with that second push stick
I build mine out of white pine only, so if when I do something stupid, it’s more likely to take a bite out of the push block - and not snatch it or drive it back into me. I embedded a magnet into one similar to your #1 and keep that stuck to the jointer base.
10/10/2 & 1 - count them all at the end of each day!
Mine are the same but wider. A 1x6 with a handle on top and cleat in back. This allows me to push both the work and drop on narrow pieces.
The tall push block with the edge lip is very similar to the push block that William Ng uses in all his classes and teaches people to use. I started using these years ago and they are an incredibly safe push block.
It’s the safest push block you can use.
I’m not sure of the side push stick you’re using, I don’t think it’s necessary, as the left over piece should just be waste and you can easily remove it once the saw is turned off.
This doesn’t seem right. Your push block contacting the blade makes the push block a workpiece. What prevents your push block kicking back when you don’t have a riving knife?
Your hand should never pass over the top of the blade push stick or no push stick, unless you have a crown guard fitted
My two cents but that looks kinda dangerous to me, you barely have any grip on it as your hand just rest on a rounded corner. Also too tall which makes it prone to trip in case of an accident
The too-tall comment sounds like you’re envisioning too much downforce. It’s a relatively gentle push in both directions, and shouldn’t be much risk of it falling over, since the hand is stabilizing it. It’s not all that tall, and being that tall is can help with positioning yourself.
As for the grip, how much more grip do you need? With a standard pus stick, you’re not using your whole hand to grip it - again, that’d be too much force.