Just started welding yesterday
It’s too cold you have to turn it up.
This calculator will help you with basic settings…https://www.millerwelds.com/en-us/resources/weld-setting-calculators/mig-flux-cored-welding-calculator
I had the voltage set to E which is a high as I can set it. How would I get it hotter?
preheat the material
Turn your wire speed down
Sell the machine and get a bigger machine. Sorry bud.
Keep your weld angle and travel speed consistent to give a uniform bead. Looking at pic 2 and 3, try to slow down and let the puddle form a bit bigger. Find a comfortable position to weld in that will allow you to maintain a steady speed and good angle, so that only your wrist/forearm move and no other part of your body.
I had my settings at 2E I cant make turn to heat up any more as E is the highest
My best advice ( and I hate being this way) is to sell that flux core and buy and old crackle box stick welder off of facebook and start there. You’re going to make it harder on yourself because you’re never really going to understand how to see and control the puddle.
For 1 day of welding experience, that’s not bad at all. It looks like you’re making the proper motions, maybe moving a bit too fast. Try moving a bit slower on the travel speed, and a bit slower/wider making your e’s or triangles. Slower movement allows a bit more heat to buildup for a wetter puddle.
A lot of how the toes tie in is determined by the timing of how long you hang at the edges of the puddle
Cool thanks man, ill give that a shot next time im out in the garage, I appreciate it!
Amps? Rod?
Settings were 2 E on my weldpak 125 Its a fluxcore corelder running .035 wire
Why cant you turn it past 2? Maybe you need to get a larger breaker? Only alternative is weld thinner steel or get new machine and new plug and new breaker.
2 is the wire feed speed
Haha i seee… that is lame. Ya you need a better machine for that steel. Unfortunately I dont think preheat is going to help that much. But does it have the option to plug into a 240v? If so, maybe try that. I have a Lincoln with an adapter to go from 110 to 240, it does all processes, but gmaw I can only get like 18V output from my welder on 120.. maybe… if im lucky. Which os not hot enough to weld that thickness. When i try to run stick, I can burn a 3⁄32 at 90 if I have it plugged into a 30a breaker. 20A and under it will burn about an inch of rod before it breaks
I might try 0.030 wire
Picture 2… add more heat and its perfect
you have potential for sure its a little too cold, try to be consistent and not go too fast
And you should have quit the day before that…. You aint cut out for this bud.
The fuck is wrong with you?
What’s your problem? Still the feeling after talking to your friends? Does that make you bitter?