Hi everyone, I need some advice (description)
It works, but I’m afraid to use it.
The wires go to the right places, so it looks fine. It could use a little hot glue on the lead connections for strain relief. Just follow the safety precautions for Li-Ion batteries and you will be okay (e.g. don’t stab it, don’t charge it unattended). Plus 650mAh is not a lot and won’t do much damage anyway.
If you didn’t change the charge current resistor it’ll be a little much for that little battery (the usual charge current is 1A). So it’ll charge fast but might reduce the lifespan of the battery.
Hey swap out tp4056 for ip2312 module doesn’t heat up as much and charges way faster
Oh, I’ve never even heard of it before, maybe I’ll install it instead of TP4056 when I figure it out, thanks
Should be fine. The pouch should have its own protection circuit (where the wires come out of the LiPo) and that TP4056 board probably also has a protection circuit (although I can’t say for sure because of the tape)If you’re worried about short circuits later on, either put more electrical tape to make sure the exposed metal can never touch or cover it in a layer of hot glue. If you ever need to modify it, a drop of isopropyl alcohol will make the hot glue release neatly
Thank you, I’ll keep that in mind.
Until you’re confident in your work, you can put it in a steel box with leads coming out the side so any fire would be contained.
Or look at the inexpensive soft sided Lipo battery storage pouches. We use them to store our radio control airplane batteries. Convenient and gives one confidence in storing LiPos when not in use.
Best wishes.